Mitsubishi Electronics WD-57831 CRT Television User Manual


  Open as PDF
of 126
 
36 Chapter 3. TV Setup
When You First Power On the TV
Choosing a Language for Menus
WhenyoupowerontheTVforthefirsttime,youcan
selecteitherEnglishorSpanishforallmenus.Youcan
laterchangethelanguagethroughtheSetupmenu.
Figure 1. The Welcome screen lets you change the menu
language when you first power on the TV.
TV Guide On Screen Setup Reminder
IfyoudonotsetuptheTVGuideOnScreensystemwhen
youfirstturnontheTV,areminderscreenwillappearthe
nextsixtimesyouturnontheTV(seefigure2).Tosetup
theTVGuideOnScreensystem,see“AdditionalSetup
withtheNetCommandMenu”laterinthischapter.
Figure 2. TV Guide On Screen setup reminder
Using the TV’s Setup Menu
UsetheSetupmenuforbasicTVsetupoptions.To
displaytheSetupmenu,press
MENU
toopentheMain
menu.WiththeSetupiconhighlighted,press
ENTER
.
Figure 3. Open the Setup menu from the Main menu.
Language (Setup Menu)
Choosetodisplayon-screenmenusineitherEnglishor
Spanish(Español).
Tolistentoaudioinotherlanguages(whenavailable),see
chapter5,“TVMenuSettings,andthe“AudioSettings”
section.Thenrefertoeither“SAP”(analogsignal)or
“Language”(digitalsignal).
Memorize Channels (Setup Menu)
For ANT 1/MAIN and ANT 2/AUX
Thememorizationprocessperformstwoscansofallpos-
siblechannelsontheselected
ANT
input.Analogchan-
nelsarescannedfirst,thentheprocessisrepeatedfor
digitalchannels.Channelmemorizationmaytakeupto15
minutestocomplete.
To start channel memorization
1. Highlightaninputselectionbasedonyourconnections:
Input Condition
Ant1Air,
Ant2Air
Whenconnectedtoanindoor/outdoor
antenna
Ant1Cable,
Ant2Cable
Whenconnectedtodirectcable(nocable
box)
2. Press
ENTER
tostartautomaticchannelmemorization.
To stop channel memorization before completion
Press
CANCEL
.
Channelsmemorizedbeforeyoupressed
CANCEL
are
retainedinmemory.Ifyourestartmemorization,allprevi-
ouslymemorizedchannelsfortheselectedantennainput
areerasedandtheprocessrestarts.
Afterchannelmemorization,press
CH
/ totuneto
memorizedchannels.SelecttheChannelmenuforfurther
channelediting,suchasaddinganddeletingchannels
frommemory,namingchannels,andsavingfavoritechan-
nelsincustommemorybanks.
 previous next