Filter
Top Products
SERVICE MODE
R5975228 BARCOVISION 701 MULTIMEDIA 070597
SERVICE MODE
SERVICE MODE
R5975228 BARCOVISION 701 MULTIMEDIA 070597
SERVICE MODE
9-89-8
Change Projector Address
Every projector requires an individual
address between O and 255. This
address can be software installed.
To change that address, push the
control disk up or down to highlight
'Change Porjector Address' and press
ENTER
. The Change Projector Ad-
dress menu will be displayed and the
actual address will be filled in.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
ENTER
displays the 'Change Projector
Address' menu.
EXIT
returns to the Service mode main
menu.
The first digit is highlighted. Select
the individual digits by pushing the
control disk to the right or to the left.
Reprogram with the digit keys on the
RCU.
Press
ENTER
to confirm.
Press
EXIT
to return to the projector
set up menu.
<ENTER> to confirm
<EXIT> to return.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use and to select,
and reprogram
with numeric keys.
Highest address is 255
Change baudrate
The communication speed between
projector and computer has 8 pos-
sible speeds. The baud rate speed
can be software set up.
Highlight 'Change Baudrate' by
pushing the control disk up or down
and press
ENTER
to display the
Baud rate menu.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Change Projector Address
Every projector requires an individual
address between O and 255. This
address can be software installed.
To change that address, push the
control disk up or down to highlight
'Change Porjector Address' and press
ENTER
. The Change Projector Ad-
dress menu will be displayed and the
actual address will be filled in.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
ENTER
displays the 'Change Projector
Address' menu.
EXIT
returns to the Service mode main
menu.
The first digit is highlighted. Select
the individual digits by pushing the
control disk to the right or to the left.
Reprogram with the digit keys on the
RCU.
Press
ENTER
to confirm.
Press
EXIT
to return to the projector
set up menu.
<ENTER> to confirm
<EXIT> to return.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use and to select,
and reprogram
with numeric keys.
Highest address is 255
Change baudrate
The communication speed between
projector and computer has 8 pos-
sible speeds. The baud rate speed
can be software set up.
Highlight 'Change Baudrate' by
pushing the control disk up or down
and press
ENTER
to display the
Baud rate menu.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO