Filter
Top Products
R5975228 BARCOVISION 701 MULTIMEDIA 070497
MESSAGES, WARNINGS AND FAILURES
MESSAGES, WARNINGS AND FAILURES
R5975228 BARCOVISION 701 MULTIMEDIA 070497
MESSAGES, WARNINGS AND FAILURES
10-3
10-3
MESSAGES, WARNINGS AND FAILURES
WARNING :
source not
available
The input is a valid input but the source is not connected
to the input terminals or the input source is switched off.
WARNING :
invalid
key entry
When a wrong key is pressed on the RCU.
WARNING :
invalid
code entry
WARNING :
end of ad-
just range
End of adjustment range.
Message when the entered password is wrong.
WARNING :
input no
longer
available
Message will be displayed when the input source is no
longer available. The following message then appears:
'check input signal or select new source'
.
check in-
put signal
or select
new source
Message will be displayed after the message
'input no
longer available'
. It asks to check the connections
between the source and the projector or to check if the
source is switched on.
WARNING :
input se-
lector not
available
It warns you to check the power connection or the power
status of the RCVDS.
Next message will appear immediatly on the screen :
'go
to stand-by'
.
WARNING :
source not
available
The input is a valid input but the source is not connected
to the input terminals or the input source is switched off.
WARNING :
invalid
key entry
When a wrong key is pressed on the RCU.
WARNING :
invalid
code entry
WARNING :
end of ad-
just range
End of adjustment range.
Message when the entered password is wrong.
WARNING :
input no
longer
available
Message will be displayed when the input source is no
longer available. The following message then appears:
'check input signal or select new source'
.
check in-
put signal
or select
new source
Message will be displayed after the message
'input no
longer available'
. It asks to check the connections
between the source and the projector or to check if the
source is switched on.
WARNING :
input se-
lector not
available
It warns you to check the power connection or the power
status of the RCVDS.
Next message will appear immediatly on the screen :
'go
to stand-by'
.