Barco R9000740 Home Theater Screen User Manual


 
R5975228 BARCOVISION 701 MULTIMEDIA 070597
SERVICE MODE
SERVICE MODE
R5975228 BARCOVISION 701 MULTIMEDIA 070597
SERVICE MODE
SERVICE MODE
9-9
9-9
The following baud rates are avail-
able :
- 9600
- 4800
- 2400
- 1200
- 600
- 300
- 150
- 110
The actual baud rate will be high-
lighted. To change the baud rate,
push the control disk up or down
or to the left or to the right to select
the desired baud rate and press
ENTER
to accept this baud rate.
<ENTER> to accept
<EXIT> to return.
BAUDRATE
Select new
baudrate :
9600 4800
2400 1200
600 300
150 110
Select with arrow
keys ;
ENTER
to accept the selected baud
rate.
EXIT
to return without changing the
baud rate.
Power up mode
When pressing the power switch,
the projector can start up in 'oper-
ating mode' or in 'stand-by mode'.
Operating mode : the projector start
up and displays image .
Stand-by mode : the projector start
up in stand-by and waits until the
stand-by button or a digit key is
pressed.
To change the Power up mode,
select Power Up mode by pushing
the control disk up or down and
press
ENTER
to toggle between
'Operating' and 'Standby'.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE :
operating
BARCO LOGO
ENTER
to toggle between operating and
standby.
EXIT
to return to the Service menu.
The following baud rates are avail-
able :
- 9600
- 4800
- 2400
- 1200
- 600
- 300
- 150
- 110
The actual baud rate will be high-
lighted. To change the baud rate,
push the control disk up or down
or to the left or to the right to select
the desired baud rate and press
ENTER
to accept this baud rate.
<ENTER> to accept
<EXIT> to return.
BAUDRATE
Select new
baudrate :
9600 4800
2400 1200
600 300
150 110
Select with arrow
keys ;
ENTER
to accept the selected baud
rate.
EXIT
to return without changing the
baud rate.
Power up mode
When pressing the power switch,
the projector can start up in 'oper-
ating mode' or in 'stand-by mode'.
Operating mode : the projector start
up and displays image .
Stand-by mode : the projector start
up in stand-by and waits until the
stand-by button or a digit key is
pressed.
To change the Power up mode,
select Power Up mode by pushing
the control disk up or down and
press
ENTER
to toggle between
'Operating' and 'Standby'.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE :
operating
BARCO LOGO
ENTER
to toggle between operating and
standby.
EXIT
to return to the Service menu.