Filter
Top Products
CONTROLLING
CONTROLLING
CONTROLLING
CONTROLLING
R5975238 BARCOVISION 701 MULTIMEDIA 070497
R5975238 BARCOVISION 701 MULTIMEDIA 070497
5-25-2
310a.DRW
Battery installation in the RCU.
fig.1
fig.2
Battery
Contact
plate
A new battery (not yet installed to save the battery life
time) is delivered inside the plastic bag with the power
cord. Before using the RCU, start first the battery
installation procedure.
Remove the battery cover on the backside of the
remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the
cover at the same time (fig. 1).
Insert the new 9 V battery (E-block type, e.g. 6F22S or
equivalent) in the lower compartment and connect the
battery to the contact plate.
Insert the battery into the lower compartment and put
the cover back.
310a.DRW
Battery installation in the RCU.
fig.1
fig.2
Battery
Contact
plate
A new battery (not yet installed to save the battery life
time) is delivered inside the plastic bag with the power
cord. Before using the RCU, start first the battery
installation procedure.
Remove the battery cover on the backside of the
remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the
cover at the same time (fig. 1).
Insert the new 9 V battery (E-block type, e.g. 6F22S or
equivalent) in the lower compartment and connect the
battery to the contact plate.
Insert the battery into the lower compartment and put
the cover back.
Insert here,
behind the
plastic cover, the
'Insert card for
RCU'. You can
cut out the
correct insert
card on one of
the last pages of
this manual.
Insert here,
behind the
plastic cover, the
'Insert card for
RCU'. You can
cut out the
correct insert
card on one of
the last pages of
this manual.