Filter
Top Products
LOCATION AND FUNCTION OF CONTROLS
LOCATION AND FUNCTION OF CONTROLS
LOCATION AND FUNCTION OF CONTROLS
LOCATION AND FUNCTION OF CONTROLS
R5975238 BARCOVISION 701 MULTIMEDIA 070497
R5975238 BARCOVISION 701 MULTIMEDIA 070497
2-6
2-6
Back light key
: when activated, all keys will be lit up and visible in the dark.
ADJ.
: adjust key, to enter or exit the adjustment mode.
Address key
(sunk key), to enter the address of the projector (between
0 and 9). Press the address key, followed by pressing one digit button
between 0 and 9.
STBY
: stand by button : - to initiate remote power up operation
- to stop projection without main power off.
Pause
:to blank the image, press PAUSE. The image disappears but full
power is retained for immediate restarting.
Digit buttons
: direct input selection.
Picture controls
: use these buttons to obtain the desired level (see also
'Controlling') for each picture function.
TEXT
: when adjusting one of the image controls during a meeting, the
displayed bar scale can be removed by pressing 'TEXT' key first. To re-
display the bar scale on the screen, press 'TEXT' key again. 'TEXT' key
is only active in operational mode. When 'TEXT' is off, no warning
message will be displayed.
ENTER
: to start up the adjustment mode or to confirm an adjustment or
selection in the adjustment mode.
EXIT
: to leave the adjustment mode or to scroll upwards when in the
adjustment mode.
Control disk
: to make menu selections when in the adjustment mode.
Also allows to increment or decrement an adjustment in the adjustment
mode.
control disk up = up arrow in the menus
control disk down = down arrow in the menus
control disk to the right = arrow to the right on the menus
control disk to the left = arrow to the left on the menus
RC operating indication
: lights up when a button on the remote control
is pressed. (This is a visual indicator to check the operation of the remote
control)
1
2
3
4
5
6
7
8
9
10
12
11
Back light key
: when activated, all keys will be lit up and visible in the dark.
ADJ.
: adjust key, to enter or exit the adjustment mode.
Address key
(sunk key), to enter the address of the projector (between
0 and 9). Press the address key, followed by pressing one digit button
between 0 and 9.
STBY
: stand by button : - to initiate remote power up operation
- to stop projection without main power off.
Pause
:to blank the image, press PAUSE. The image disappears but full
power is retained for immediate restarting.
Digit buttons
: direct input selection.
Picture controls
: use these buttons to obtain the desired level (see also
'Controlling') for each picture function.
TEXT
: when adjusting one of the image controls during a meeting, the
displayed bar scale can be removed by pressing 'TEXT' key first. To re-
display the bar scale on the screen, press 'TEXT' key again. 'TEXT' key
is only active in operational mode. When 'TEXT' is off, no warning
message will be displayed.
ENTER
: to start up the adjustment mode or to confirm an adjustment or
selection in the adjustment mode.
EXIT
: to leave the adjustment mode or to scroll upwards when in the
adjustment mode.
Control disk
: to make menu selections when in the adjustment mode.
Also allows to increment or decrement an adjustment in the adjustment
mode.
control disk up = up arrow in the menus
control disk down = down arrow in the menus
control disk to the right = arrow to the right on the menus
control disk to the left = arrow to the left on the menus
RC operating indication
: lights up when a button on the remote control
is pressed. (This is a visual indicator to check the operation of the remote
control)
1
2
3
4
5
6
7
8
9
10
12
11