Filter
Top Products
R5975238 BARCOVISION 701 MULTIMEDIA 070497
APPENDIX F : SOURCE NUMBERS 90 - 99
APPENDIX F : SOURCE NUMBERS 90 - 99
R5975238 BARCOVISION 701 MULTIMEDIA 070497
APPENDIX F : SOURCE NUMBERS 90 - 99
APPENDIX F : SOURCE NUMBERS 90 - 99
F-1
F-1
Source numbers 90 - 99
Source numbers 90 - 99 do not correspond to physical inputs to the projector or
RCVDS05. They are used to assign an additional adjustment block to a source. This
additional adjustment block may contain different geometry and convergence set-
tings, sync fast/slow positions and enhanced blue on/off settings. The relationship
between source numbers 0 - 9 and 90 - 99 (projector with RCVDS) or 1 - 5 and 91
- 95 (stand-alone projector) is shown in the diagram below.
The alternate adjustment block for sources 0 - 9 (projector with RCVDS) or 1 - 5
(stand-alone projector) is activated by selecting the corresponding source number
0 - 9 (projector with RCVDS) or 1 - 5 (stand-alone projector). Once this source
number is selected, the alternate block of adjustment data is in use and may be
modified via the adjust mode of the projector. The alternate adjustment block is
automatically stored.
source input 0
source number 0
source number 90
source number 1
source number 91
source number 2
source number 92
source number 9
source number 99
Block header A
Block header A, different
analog settings
source input 2
source input 1
source input 9
Block header B
Block header B, different
analog settings
Block header C
Block header C, different
analog settings
Block header J
Block header J, different
analog settings
Source numbers 90 - 99
Source numbers 90 - 99 do not correspond to physical inputs to the projector or
RCVDS05. They are used to assign an additional adjustment block to a source. This
additional adjustment block may contain different geometry and convergence set-
tings, sync fast/slow positions and enhanced blue on/off settings. The relationship
between source numbers 0 - 9 and 90 - 99 (projector with RCVDS) or 1 - 5 and 91
- 95 (stand-alone projector) is shown in the diagram below.
The alternate adjustment block for sources 0 - 9 (projector with RCVDS) or 1 - 5
(stand-alone projector) is activated by selecting the corresponding source number
0 - 9 (projector with RCVDS) or 1 - 5 (stand-alone projector). Once this source
number is selected, the alternate block of adjustment data is in use and may be
modified via the adjust mode of the projector. The alternate adjustment block is
automatically stored.
source input 0
source number 0
source number 90
source number 1
source number 91
source number 2
source number 92
source number 9
source number 99
Block header A
Block header A, different
analog settings
source input 2
source input 1
source input 9
Block header B
Block header B, different
analog settings
Block header C
Block header C, different
analog settings
Block header J
Block header J, different
analog settings