Filter
Top Products
SERVICE MODE
R5975228 BARCOVISION 701 MULTIMEDIA 070597
SERVICE MODE
SERVICE MODE
R5975228 BARCOVISION 701 MULTIMEDIA 070597
SERVICE MODE
9-209-20
Projector warm up
Select with or
then <ENTER>
<EXIT> to return.
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
Highlight 'Projector warm up' by push-
ing the control disk up or down and
press
ENTER
to select the projector
warm up menu.
PROJECTOR WARM UP
OPTION : ON
A FULL WHITE PATTERN
WILL BE GENERATED FOR
20 MINUTES AT POWER UP
AFTER THIS PROCEDURE
THE PROJECTOR IS READY
TO PERFORM IN OPTIMUM
CONDITION
TOGGLE OPTION ON OR OFF
with <ENTER>
<EXIT> to return
The ON/OFF option can be toggled
with the
ENTER
key.
When in the ON position (and the
CRT run in cycle is OFF), the projec-
tor can start up with a warm up
periode of 20 minutes. During the
start up a warm up menu will be
displayed. This menu offers the
possibility to skip the warm up periode
anyway by pressing the
EXIT
key
and offers the possibility to adjust
the horizontal and vertical amplitude
of this white image with the control
disk. During this warm up period, a
full white image is shifted on the CRT
faceplate to avoid a burn in.
Every 30 seconds a text box will be
displayed on another place on the
screen with the remaining time to go.
When
EXIT
is pressed during this
warm up periode, the warm up menu
will be redisplayed with the remain-
ing time indication. Press another
time
EXIT
to interrupt the warm up
cycle.
When the warm up option is OFF,
when switching on the projector, it
starts immediately with the projec-
tion of the selected source
Projector warm up
Select with or
then <ENTER>
<EXIT> to return.
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
Highlight 'Projector warm up' by push-
ing the control disk up or down and
press
ENTER
to select the projector
warm up menu.
PROJECTOR WARM UP
OPTION : ON
A FULL WHITE PATTERN
WILL BE GENERATED FOR
20 MINUTES AT POWER UP
AFTER THIS PROCEDURE
THE PROJECTOR IS READY
TO PERFORM IN OPTIMUM
CONDITION
TOGGLE OPTION ON OR OFF
with <ENTER>
<EXIT> to return
The ON/OFF option can be toggled
with the
ENTER
key.
When in the ON position (and the
CRT run in cycle is OFF), the projec-
tor can start up with a warm up
periode of 20 minutes. During the
start up a warm up menu will be
displayed. This menu offers the
possibility to skip the warm up periode
anyway by pressing the
EXIT
key
and offers the possibility to adjust
the horizontal and vertical amplitude
of this white image with the control
disk. During this warm up period, a
full white image is shifted on the CRT
faceplate to avoid a burn in.
Every 30 seconds a text box will be
displayed on another place on the
screen with the remaining time to go.
When
EXIT
is pressed during this
warm up periode, the warm up menu
will be redisplayed with the remain-
ing time indication. Press another
time
EXIT
to interrupt the warm up
cycle.
When the warm up option is OFF,
when switching on the projector, it
starts immediately with the projec-
tion of the selected source