Barco R9000740 Home Theater Screen User Manual


 
R5975238 BARCOVISION 701 MULTIMEDIA 070497
APPENDIX B : ORBITING
APPENDIX B : ORBITING
R5975238 BARCOVISION 701 MULTIMEDIA 070497
APPENDIX B : ORBITING
APPENDIX B : ORBITING
B-3
B-3
Orbiting speed toggle (only in MASTER Orbiting)
Highlight
'SPEED : SLOW'
with
the coontrol disk and press
EN-
TER
to set the ORBITING SPEED
to Fast.
Highlight
'SPEED : FAST'
with the
control disk and press
ENTER
to
set the ORBITING SPEED to Slow
ENTER
continues to Set up Orbiting.
EXIT
returns to the Path Selection menu.
ADJUST
returns to the Operational mode.
Orbiting alignment
Preparation :
Before proceeding to the alignment of the Orbiting default settings, be sure that
the Horizontal Phase and the Raster shift are correctly aligned with the Orbiting
mode set to OFF.
This alignment must be performed in case of a multiple projector installation with
Master and Slave projectors in order to ensure a correct operation of the Orbiting
for all projectors.
Adjustment procedure stand alone projector :
Highlight
'ADJUST DEVIATION'
with the control disk and press
ENTER
.
MASTER ORBITING
<EXIT> to return
SELECT WITH OR
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH OR
HORIZONTAL WITH OR
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION
MASTER ORBITING
<EXIT> to return
SELECT WITH OR
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH OR
HORIZONTAL WITH OR
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION
Orbiting speed toggle (only in MASTER Orbiting)
Highlight
'SPEED : SLOW'
with
the coontrol disk and press
EN-
TER
to set the ORBITING SPEED
to Fast.
Highlight
'SPEED : FAST'
with the
control disk and press
ENTER
to
set the ORBITING SPEED to Slow
ENTER
continues to Set up Orbiting.
EXIT
returns to the Path Selection menu.
ADJUST
returns to the Operational mode.
Orbiting alignment
Preparation :
Before proceeding to the alignment of the Orbiting default settings, be sure that
the Horizontal Phase and the Raster shift are correctly aligned with the Orbiting
mode set to OFF.
This alignment must be performed in case of a multiple projector installation with
Master and Slave projectors in order to ensure a correct operation of the Orbiting
for all projectors.
Adjustment procedure stand alone projector :
Highlight
'ADJUST DEVIATION'
with the control disk and press
ENTER
.
MASTER ORBITING
<EXIT> to return
SELECT WITH OR
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH OR
HORIZONTAL WITH OR
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION
MASTER ORBITING
<EXIT> to return
SELECT WITH OR
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH OR
HORIZONTAL WITH OR
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION