Filter
Top Products
D-131
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
Service State Displays the service state:
• IS_NR—In Service–Normal.
• OOS_AU—Out of Service–Autonomous.
• OOS_MA—Out of Service–Management.
• OOS_AUMA—Out of Service–Autonomous and Management.
In addition, a secondary state provides additional information about the status of the entity.
Values for secondary state are:
• MEA—Mismatch of equipment due to invalid equipment insertion.
• UEQ—Unequipped; there is nothing in the slot.
• UAS—Unassigned; the entity does not exist, has not been created, or has been deleted.
• SWDL—Software download in progress.
• MT—Maintenance, as per the Admin State change.
• AINS—Automatic in service.
• DSBLD—Traffic is disabled on the entity.
• LPBK—Port or connection has a loopback on it.
• FLT—Fault secondary state. When an entity is faulted, an FLT state is raised. Equipment
and ports in FLT state should be cleared as they transition. Transition states are listed in
Table 11-10 on page 11-15.
See Table 11-10 on page 11-15 for the Service state/Secondary state possible values.
Note If the NE does not support the Service State, this field shows N/A.
Synchronization Status
Message
Allows you to view the incoming synchronization status message. Values are:
• PRS (Primary reference source Stratum 1)
• STU (Sync traceability unknown)
• ST2 (Stratum 2)
• ST3 (Stratum 3)
• ST3E (Stratum 3E)
• SMC (SONET minimum clock)
• ST4 (Stratum 4)
• TNC (Transit node clock)
• DUS (Do not use for timing synchronization)
• RES (Reserved; quality level set by user)
BLSR Ext. Byte Select an alternate BLSR byte. Choices are Z2, E2, or F1.
Type Defines the port as SONET or SDH.
Section Thresh 15 Minutes
Port Number The optical port number.
CV-S Coding violations–section.
Table D-138 Field Descriptions for the Line Tab (continued)
Subfield Description