Filter
Top Products
D-160
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
D.4.12.4 WAN Line Tab
The WAN Line tab allows you to view and configure wide-area network (WAN) line information.
Note See Table 1-20 on page 1-44 for descriptions of actions that can be performed using the buttons at the
bottom of the window.
D.4.13 Slot Properties—S16.1-1-LC (ONS 15305 CTC)
The S16.1-1-LC module contains one optical STM-16 interfaces that meets the S-16.1 specification in
ITU-T G.957. The physical connector is an LC connector. The module only supports TDM traffic.
The Slot Properties pane displays information about the Cisco ONS 15305 CTC slot that is selected in
the NE Explorer tree. Use this properties pane to change the module performance monitoring thresholds.
A module diagram is shown in the following figure.
Figure D-4 Single Optical S-16.1 Module, S16.1-1-LC
For the S16.1-1-LC module, the Slot Properties pane displays the following tabs: Module View,
Identification, STM Line, VC-4 Config, and Loopback.
D.4.13.1 Module View Tab
The Module View tab displays a graphic of the S16.1-1-LC that is installed in the slot. The number of
critical, major, minor, and warning alarms for the module is displayed under Alarm Status. (Alarms are
also displayed when you move the mouse pointer over the graphic.) The Suppress Alarms check box is
read-only and indicates whether all alarms are suppressed for the card and its port(s). Right-clicking the
graphic opens a shortcut menu that you can use to reset, delete, or change the card.
Table D-170 Field Descriptions for the WAN Line Tab
Field Description
Port Number Displays the optical port number.
Port Name Allows you to enter an optical port name.
Link State Displays the physical port state. Possible values are Up, Down, or Not Present.
96701
MOD
FAIL
MOD
DIS
CLASS 1
LASER
PRODUCT
S16.1-1-LC
INOUT