Filter
Top Products
D-78
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
PJSTSMon# Sets the STS that will be used for pointer justification. If set to 0, no STS is monitored. Only one STS
can be monitored on each OC-N port.
• 0 (Cisco default) - 3 (OC3, per port)
• 0 (Cisco default) - 12 (OC-12)
• 0 (Cisco default) - 48 (OC-48)
ProvidesSync If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg Enables synchronization status messages (S1 byte), which allow the node to choose the best timing
source.
Send DoNotUse When checked, sends a do not use (DUS) message on the S1 byte.
Admin State The port administration state. Choosing an administrative state from the drop-down list and clicking
Apply changes the port’s service state unless network conditions prevent the change. Admin states
include:
• IS—In Service. The port service state changes to IS_NR.
• OOS,DSBLD—Out of Service, Disabled. The port service state changes to OOS_MA, DSBLD.
• OOS, MT—Out of Service, Maintenance. The port service state changes to OOS_MA, MT. For
loopbacks, the OOS, MT admin state must be initiated.
• IS, AINS—Automatic In Service. The port service state changes to OOS_AU, AINS.
AINS Soak Automatic in-service soak. The determination of duration left before the traffic/termination
transitions to IS state.
AINS Soak Count
Down
Automatic in-service soak countdown. Displays the remaining time of valid input signal in hh:mm,
after which the card becomes in service (IS) automatically.
Table D-91 Field Descriptions for the Line Tab (continued)