Filter
Top Products
D-44
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Multirate Cards
Service State Overall availability of the entity. Values are:
• IS_NR—In Service–Normal.
• OOS_AU—Out of Service–Autonomous.
• OOS_MA—Out of Service–Management.
• OOS_AUMA—Out of Service–Autonomous and Management.
In addition, a secondary state provides additional information about the status of the
entity. Values for secondary state are:
• MEA—Mismatch of equipment due to invalid equipment insertion.
• UEQ—Unequipped. There is nothing in the slot.
• UAS—Unassigned. The entity does not exist, has not been created, or has been
deleted.
• SWDL—Software download in progress.
• MT—Maintenance, as per the Admin State change.
• AINS—Automatic In Service.
• DSBLD—Traffic is disabled on the entity.
• LPBK—Port or connection has a loopback on it.
• FLT—Fault secondary state. When an entity is faulted, an FLT state is raised.
Equipment and ports in FLT state should be cleared as they transition. Transition
states are listed in Table 11-10 on page 11-15.
See Table 11-10 on page 11-15 for the Service state/Secondary state possible values.
Note If the NE release does not support the Service state, this field shows N/A.
SF BER Sets the signal fail bit error rate.
SD BER Sets the signal degrade bit error rate.
Provide Sync If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg When checked, enables synchronization status messages, which allow the node to choose
the best timing source.
Send Do Not Use When checked, sends a do not use (DUS) message on the S1 byte.
BLSR Ext. Byte Select an alternate BLSR byte.
Type Defines the port.
AINS Soak (H:M) Automatic in-service soak. The determination of duration left before the
traffic/termination transitions to IS state.
AINS Soak Count Down (H:M) Automatic in-service soak countdown. Displays the remaining time of valid input signal
in hh:mm, after which the card becomes in service (IS) automatically.
Table D-51 Field Descriptions for the Line Config Subtab (continued)
Field Description