Filter
Top Products
D-34
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Multirate Cards
D.3.1.12 Ether Loopback Tab
The Ether Loopback tab allows loopback to be configured in the Ether port. The Ether Loopback tab
contains the following subtabs:
• D.3.1.12.1 Ether Loopback Port Subtab, page D-35
• D.3.1.12.2 SONET STS (Ether) Subtab, page D-35
Reach Allows you to provision the reach value. You can choose Auto Provision, which allows the system
to automatically provision the reach from the PPM reach value on the hardware. Choose one of the
following reach distances:
Note The reach distances options that appear in the drop-down list depend on the card selected.
• SR (short reach, up to 2km distance)
• SR 1 (up to 2km distance)
• IR 1 (intermediate reach, up to 15km distance)
• IR 2 (up to 40kmm distance)
• LR 1 (long reach, up to 40km distance)
• LR 2 (up to 80km distance)
• LR 3 (up to 80km distance)
• I1
• S1
• S2
• L1
• L2
• L3
• SX (up to 550m or 270m distance based on 50um/62.5um diameter fiber)
• LX (up to 10km or 550m distance based on 50um/62.5um diameter fiber)
• CX
• T
• DX (up to 40km distance)
• HX (up to 40km distance)
• ZX (up to 80km distance)
• VX (up to 100km distance)
Wavelength Allows you to provision the wavelength frequency.
AINS Soak (H:M) Automatic in-service soak. The determination of duration left before the traffic/termination
transitions to IS state.
AINS Soak Count Down
(H:M)
Automatic in-service soak countdown. Displays the remaining time of valid input signal in hh:mm,
after which the card becomes in service (IS) automatically.
Table D-40 Field Descriptions for the Ether Line Tab (continued)
Field Description