Filter
Top Products
D-24
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Multirate Cards
D.3.1.4.2 Line Thresh 15 Min Subtab
The Line Thresh 15 Min subtab allows you to view and change the 15-minute near- and far-end line
thresholds of the ASAP_4 card.
Reach Allows you to provision the reach value. You can choose Auto Provision, which allows
the system to automatically provision the reach from the PPM reach value on the
hardware. Choose one of the following reach distances:
Note The reach distances options that appear in the drop-down list depend on the card
selected.
• SR (short reach, up to 2km distance)
• SR 1 (up to 2km distance)
• IR 1 (intermediate reach, up to 15km distance)
• IR 2 (up to 40kmm distance)
• LR 1 (long reach, up to 40km distance)
• LR 2 (up to 80km distance)
• LR 3 (up to 80km distance)
• I1
• S1
• S2
• L1
• L2
• L3
• SX (up to 550m or 270m distance based on 50um/62.5um diameter fiber)
• LX (up to 10km or 550m distance based on 50um/62.5um diameter fiber)
• CX
• T
• DX (up to 40km distance)
• HX (up to 40km distance)
• ZX (up to 80km distance)
• VX (up to 100km distance)
Wavelength Allows you to provision the wavelength frequency.
AINS Soak (H:M) Automatic in-service soak. The determination of duration left before the
traffic/termination transitions to IS state.
AINS Soak Count Down (H:M) Automatic in-service soak countdown. Displays the remaining time of valid input signal
in hh:mm, after which the card becomes in service (IS) automatically.
Table D-23 Field Descriptions for the Line Config Subtab (continued)
Field Description