Filter
Top Products
D-139
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
PJSTSMon# Sets the STS that will be used for pointer justification. If set to 0, no STS is monitored. Only one
STS can be monitored on each OC-N port.
• 0 (Cisco default)–3 (OC3, per port)
• 0 (Cisco default)–12 (OC-12)
• 0 (Cisco default)–48 (OC-48)
ProvidesSync If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg Enables synchronization status messages (S1 byte), which allow the node to choose the best
timing source.
Admin SSM If the node does not receive an SSM signal, it defaults to STU (synchronization traceability
unknown). Admin SSM allows you to override the STU value with one of the following:
• PRS—Primary reference source (Stratum 1)
• STS2—Stratum 2
• TNC—Transit node clock
• STS3E—Stratum 3E
• STS3—Stratum 3
• SMC—SONET minimum clock
• ST4—Stratum 4
Send DoNotUse When checked, sends a do not use (DUS) message on the S1 byte.
Admin State Select the designation that drives whether an entity is in service or out of service. The Admin
state is the driver for the Service state.
Table D-146 Field Descriptions for the Line Tab (continued)
Subfield Description