Filter
Top Products
D-183
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
SD BER Sets the signal degrade bit error rate.
SF BER Sets the signal fail bit error rate.
ProvidesSync If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg Enables synchronization status messages (S1 byte), which allow the node to choose the best timing
source.
Send DoNotUse When checked, sends a DNS (do not use) message on the S1 byte.
Admin State Select the designation that drives whether an entity is in service or out of service. The Admin state is
the driver for the Service state.
Service State Displays the service state:
• IS_NR—In Service–Normal.
• OOS_AU—Out of Service–Autonomous.
• OOS_MA—Out of Service–Management.
• OOS_AUMA—Out of Service–Autonomous and Management.
In addition, a secondary state provides additional information about the status of the entity. Values for
secondary state are:
• MEA—Mismatch of equipment due to invalid equipment insertion.
• UEQ—Unequipped; there is nothing in the slot.
• UAS—Unassigned; the entity does not exist, has not been created, or has been deleted.
• SWDL—Software download in progress.
• MT—Maintenance, as per the Admin State change.
• AINS—Automatic in service.
• DSBLD—Traffic is disabled on the entity.
• LPBK—Port or connection has a loopback on it.
• FLT—Fault secondary state. When an entity is faulted, an FLT state is raised. Equipment and ports
in FLT state should be cleared as they transition. Transition states are listed in Table 11-10 on page
11-15.
See Table 11-10 on page 11-15 for the Service state/Secondary state possible values.
Note If the NE does not support the Service State, this field shows N/A.
Synchronization
Status Message
SDH protocol that communicates information about the quality of the timing source.
MS-SPRing Ext.
Byte
Select an alternate MS-SPRing byte.
Type Defines the port.
MS Thresh 15 Min (Near End)
Port Number The port number
EB-MS Errored block–multiplex section
ES-MS Errored seconds–multiplex section
SES-MS Severely errored seconds–multiplex section
Table D-202 Field Descriptions for the Line Tab (continued)
Field Description