Filter
Top Products
D-37
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Multirate Cards
D.3.1.15 Transceiver Tab
The Transceiver tab allows you to view and update ASAP_4 transceiver information.
Table D-45 Field Descriptions for the POS Line Tab
Field Description
Port Number Displays the card port number.
Port Name Allows you to enter a port name.
Admin State The port administration state. It can be:
• IS—In Service.
• IS, AINS—Automatic In Service.
• OOS, DSBLD—Out of Service, Disabled.
• OOS, MT—Out of Service, Maintenance.
Service State Overall availability of the entity. Values are:
• IS_NR—In Service–Normal.
• OOS_AU—Out of Service–Autonomous.
• OOS_MA—Out of Service–Management.
• OOS_AUMA—Out of Service–Autonomous and Management.
In addition, a secondary state provides additional information about the status of the entity. Values
for secondary state are:
• MEA—Mismatch of equipment due to invalid equipment insertion.
• UEQ—Unequipped. There is nothing in the slot.
• UAS—Unassigned. The entity does not exist, has not been created, or has been deleted.
• SWDL—Software download in progress.
• MT—Maintenance, as per the Admin State change.
• AINS—Automatic In Service.
• DSBLD—Traffic is disabled on the entity.
• LPBK—Port or connection has a loopback on it.
• FLT—Fault secondary state. When an entity is faulted, an FLT state is raised. Equipment and
ports in FLT state should be cleared as they transition. Transition states are listed in Table 11-10
on page 11-15.
See Table 11-10 on page 11-15 for the Service state/Secondary state possible values.
Note If the NE release does not support the Service state, this field shows N/A.
Encap CRC Sets the cyclic redundancy check (CRC) to verify the integrity of the transmitted data.
Framing Type Allows you to select the line framing type.
Link State Displays the physical port state. Possible values are Up and Down.
MTU Maximum transfer unit. The largest acceptable packet size configured for that port. The Cisco
default value is 1500.