Filter
Top Products
Solutions
Rev 3.01 95 Document 900.0315
10/05
C
Solutions
This appendix provides solutions to common technical issues.
Problem Possible solution
No power • Check power cord connections.
• Confirm that there is power at the outlet.
No live video • Check camera video cable and connections.
• Check monitor video cable and connections.
• Confirm that the camera has power.
• Check camera lens settings.
• Check CVBS(SVHS)/VGA switch settings.
Live video extremely bright If a cable is attached to the "Loop" connector, make
certain it is connected to a properly terminated
device.
DVR stops recording If the hard disk drive is full, you need to either delete
video or set the DVR to the Overwrite Mode.
DVR displays an error
message that the last recorded
image date and time is later
than the current date and time
setting of the DVR
The DVR automatically resets the time and date of the
unit, according to the time and date of the last
recorded image.
If this is not the correct time and date, reset the time
and date manually.
If the correct time and date is earlier than the last
recorded image, any video with a later time and date
will be lost when resetting the correct time and date.