Filter
Top Products
Configuration
Rev 3.01 41 Document 900.0315
10/05
On means the Alarm Out is active during the scheduled time.
Event indicates the Alarm Out is only active when there is an Event during the
scheduled time.
Audio Setup Screen
Use the Audio Setup screen to set the DVR to record audio when it is recording video.
Highlight Audio in the Device menu (MENU ➤ Device ➤ Audio) and then press # .
The Audio Setup screen displays.
Figure 3-26 Audio Setup Screen
1. Highlight the box beside Audio Recording and then press # . This toggles
between On and Off. When it is On, the DVR also records audio when it is
recording video.
2. Highlight the box beside Mute and then press # . This toggles between On and
Off. When it is On, the DVR does not play live or recorded audio.
3. The DVR supports four audio inputs. You can set up each input. When it is On, the
DVR plays live audio through the attached speaker when it displays live video.
Highlight the Audio In field, highlight the box under the On/Off heading, and then
press # . This toggles between On and Off.
4. To save your changes, highlight OK and then press # . Select Cancel to exit the
screen without saving the changes.
Note The DVR will NOT record audio when the recording speed is set
to less than 15 ips (12.5 ips PAL). The DVR may not record audio
depending on the Transfer Speed when the RAS (Remote
Administration System) Watch program is connected.