Filter
Top Products
Configuration
Rev 3.01 60 Document 900.0315
10/05
4. The Transfer Speed indicates the image rate transferred to each RAS. Highlight
the box beside Transfer Speed, press # then adjust the number.
Note The maximum transfer speed over a LAN is 30 images per
second (25 ips for PAL) when the resolution is set to Standard.
However, when set to High the transfer speed will decrease to 15
images per second (12.5 ips for PAL).
5. You can program the image quality for transferring to RAS. Highlight the box
beside Remote Quality and then press # . You can set the image quality to Very
High, High, Standard, or Low.
LAN Setup Screen
Use the LAN Setup screen to configure your Local Area Network.
Figure 3-47 LAN Setup Screen
Highlight the box beside Type and then press # .to select from Manual, DHCP, and
ADSL (PPPoE).
Selecting Manual from Type allows you to set up LAN parameters manually.
LAN Setup — Manual
Note Obtain the appropriate IP Address, Gateway and Subnet Mask
from your network administrator.
Change the numbers by highlighting them and using the Up and Down Arrow buttons
or the Jog Dial to increase or decrease the numbers.