Filter
Top Products
Operation
Rev 3.01 76 Document 900.0315
10/05
Figure 4-1 DVR Front Panel
The front panel controls are described in Chapter 3, Configuration.
Turning on the Power
After you have installed the DVR following the instructions in Chapter 2, Installation, it is
ready to record. The unit takes approximately 60 seconds to initialize.
The DVR recovers automatically after the unit is initialized if recorded data on the
storage device has been damaged.
Live Monitoring
As soon as the DVR completes its initialization process, it will begin showing live video
on the attached monitor and playing live audio through the attached speaker. The
default mode is to display all four cameras at the same time. Pressing any camera
button causes that camera to display full screen. It displays live video and plays live
audio until the user enters another mode.
Press QUAD/SEQ to toggle between quad (2x2) display mode and sequence mode.
Press ENTER in Live Monitoring mode to freeze the current image on the screen until
you press the ENTER button again. The screen displays
✱.
You can set the DVR to display the event-detected video in full-screen on the monitor
during the preset dwell time when there is an Event. The video of the lowest camera
number among cameras associated with the event-detected sensor displays and the
DVR returns to the previous screen format after event monitoring dwell time. While the
event monitoring is activated, the monitoring for all other subsequent events is ignored.
Pressing any individual camera button or QUAD/SEQ during event monitoring releases
the current event monitoring and displays the selected camera or returns to the
previous screen format.