Filter
Top Products
Configuration
Rev 3.01 47 Document 900.0315
10/05
Time-Lapse Recording Schedule
Figure 3-30 Time-Lapse Recording Schedule Screen
You can program the DVR to record only during certain times based on time, day of the
week, and holidays. The smallest time segment you can use is 30 minutes. A blue
rectangle indicates the DVR is set to record during those 30 minutes. When there is no
rectangle, the DVR will not record during those 30 minutes.
There are several ways to set recording times:
• You can highlight an individual block and toggle it On or Off by pressing # .
• You can change a 30-minute segment for all days by placing the cursor on the
time line and then pressing # to toggle the segment On or Off.
• You can change an entire day by placing the cursor on the day of the week and
then pressing # to toggle the day On or Off.
• You can change the entire calendar by placing the cursor in the upper left-hand
box (above S and to the left of the time line) and then pressing # to toggle the
entire calendar On and Off.
Note The Holiday (H) schedule applies to the dates you established as
holidays when setting Date/Time.
To save your changes, highlight OK and then press # . Select Cancel to exit the screen
without saving the changes.