Filter
Top Products
13
Basic Operation
Switching the Power On/Off
Switching the Power On
1
Connect the power cable.
Connect using the power cable supplied to an AC 120V -
240V 50Hz/60Hz outlet.
2 Turn on the power switch on the rear panel.
• A system check will run when the power is turned on.
• The [OPERATE] indicator will blink.
• After blinking, the [OPERATE] indicator will light up to
indicate that operation has been turned on.
• When the settings have been completed, recording
operation is started automatically with record control
mode.
CAUTION
• Do not disconnect the power cord nor turn the power
switch off while the system check is running or in the
OPERATE ON mode as this may cause a malfunction.
Switching the Power Off
1
Press and hold the [OPERATE] button for
about 2 seconds to turn operation off.
After blinking, the [OPERATE] indicator will go off.
2 Turn off the power switch on the rear panel.
CAUTION
• The recorded images may not play back properly if they
were not archived ( Page 63) before the power failure.
• It is recommended that an uninterruptible power supply
(UPS) be used to protect the hard disk from damage in
the event of a power failure. ( Page 79)
Switching Operation On/Off by
Pressing the Button on the Front Panel
You are able to switch operation on or off.
Switching Operation On
1
(With operation off) Press the [OPERATE]
button.
• The [OPERATE] indicator will blink.
• The [OPERATE] indicator will light up, indicating that the
system is operable.
Note
• When the power switch on the rear panel is turned on, the
system starts up to initiate a system check until the
OPERATE ON mode is activated.
Switching Operation Off
1
(With operation on) Press and hold the
[OPERATE] button for about 2 seconds.
• The [OPERATE] indicator will blink.
• The screen will go blank and the [OPERATE] indicator will
go off, indicating that operation has been turned off.
CAUTION
• Do not turn off the power until operation has been turned
off.
☞
☞