Filter
Top Products
Basic Operation
30
Printing the Recorded Images
You may print the playback image that is displayed.
CAUTION
• This function is not available with the VR-N900U.
• This function is for the downloaded VR-N900 Viewer.
1
Double click the [Print] bar in the [Browse] window.
2
Click the [Print…] button in the [Print] section.
[VR-N900 Viewer Surveillance Report] window is
displayed.
3 Click the [Page Setup] button in the [VR-N900U
Surveillance Report] window to set the printer.
4 Click the [Print] button to start printing.
When the printing ends, click the [Close] button to close the
print window.
Comments entered in [User’s Note:] are printed.
Recording Camera Images
Recording Modes
●Recording Control Mode
In this mode, recording is carried out in accordance with the
[Camera Record Setting].
The [REC CONTROL] indicator is lit.
You are able to switch the recording control mode on or off
by pressing and holding the [REC CONTROL] button.
• Set online/offline periods for each camera with the
[Scheduler] settings. ( Page 32)
• Specify the frame rate and conditions for starting
recording in [Camera Settings]. ( Page 34)
CAUTION
• The camera will not record during the offline periods
specified in the [Scheduler] settings, regardless of the
[Camera Settings].
• The [REC CONTROL] button is disabled when the Main
Menu is displayed, when settings are being specified and
during recording.
• When there is an unconnected camera, time may be
required for the [REC CONTROL] indicator lamp to light up.
Note
• Press the [REC/STOP] button to cancel recording control
mode and enable manual recording mode.
• Press and hold down the [REC/STOP] button to cancel all
recording modes and stop recording.
• Set [Operate] to ON to automatically enter the recording
control mode.
●Manual Recording Mode
Manual recording is a recording mode that executes
recording from all cameras regardless of the settings in the
[Camera Record Setting]. It will be recorded at the frame
rate that was set in [Image Storage settings] - [Desired
framerate settings] of the [Camera Settings] window.
Manual recording lets you start and stop recording from all
cameras by pressing the [REC/STOP] button. Press the
[REC/STOP] button to start recording and press and hold it
down to end recording. Holding down the [REC/STOP]
button when recording is not on will not start recording.
The [REC CONTROL] indicator is off.
●Recording by EXT REC IN Signal Mode
Recording will start from all cameras when the [EXT REC
IN] terminal on the rear panel is set to MAKE state. It will be
recorded at the frame rate that was set in [Image Storage
settings] - [Desired framerate settings] of the [Camera
Settings] window.
[Browse] window
☞
☞