Filter
Top Products
45
● Buttons
Service Manager:
The [Service Manager] button opens the small [Service
Manager] window, which lets you pause/resume the
recording program “Recording Server”. Pausing the
service is necessary in order to access some features, for
example configuration of PTZ cameras.
CAUTION
• While the service is paused, video or audio will not be
recorded. Also, the live images to the surveillance
computer are turned off.
Scheduler:
Opens the [Camera/Alert Scheduler] window. ( Page
32)
General Settings:
Opens the [General Settings] window. ( Page 61)
Archive Setup:
Opens the [Archive setup] window. ( Page 63)
Matrix:
This setup is required when the Milestone XProtect Matrix
is used. For details, refer to the Milestone XProtect Matrix
manual.
(http://www.milestonesys.com/?cid=265)
Add Device:
Starts the [Device Setup Wizard]. ( Page 46)
Edit Device:
Opens the [Edit device settings] window. ( Page 47)
Remove Device:
Lets you remove a device selected in the [Device
Manager] section.
CAUTION
• If you remove the device, you will not be able to view live
images.
In future, select [Disabled] in [Camera Monitor Setup]
( Page 34) in the [Camera Settings] window without
removing the device required for viewing live images. To
view live images, cancel [Disabled] in [Camera Monitor
Setup].
Settings:
Lets you specify settings for a selected camera ( Page
34) or audio device ( Page 44).
I/O Setup:
Opens the [I/O Setup] window. ( Page 53)
Event Buttons:
Opens the [Event Buttons] window. ( Page 56)
Generic Events:
Opens the [Generic Events] window. ( Page 57)
I/O Control:
Opens the [I/O Control] window. ( Page 59)
Exit:
Closes the [Camera Record Setting] window.
● Analog Cameras
In the VR-N900U, analog input circuitry is considered a
network encoder (IP video server) and the IP address
192.168.201.12 has been set. The registered address [N900
(192.168.201.12)] will appear in the [Device Manager]
section on the [Camera Record Setting] window.
The analog cameras that are connected to [VIDEO IN 1-4]
terminals on the rear panel correspond to N900 cameras 1
to 4.
You can change the default name (N900) by clicking the
[Edit Device] button, but you cannot change the IP address
(192.168.201.12).
Note
• The audio signal which is inputted into [AUDIO IN] audio
input terminal 1 and 2 of the rear panel will record and
archive as the audio of the analog camera which is
connected to [VIDEO IN] camera image signal input
terminal 1 and 2. (Same applies for the network encoder
which has the multiple image and audio input terminals of
VN-E4, etc.)
☞
☞
☞
☞
☞
☞
☞
☞
☞
☞
☞
☞