39
● Buttons
Service Manager:
The [Service Manager] button opens the small [Service
Manager] window, which lets you pause/resume the
recording program “Recording Server”. Pausing the
service is necessary in order to access some features, for
example configuration of PTZ cameras.
CAUTION
• While the service is paused, video or audio will not be
recorded. Also, the live images to the surveillance
computer are turned off.
Scheduler:
Opens the [Camera/Alert Scheduler] window. ( Page
26)
General Settings:
Opens the [General Settings] window. ( Page 55)
Archive Setup:
Opens the [Archive setup] window. ( Page 57)
Matrix:
This setup is required when the Milestone XProtect Matrix
is used. For details, refer to the Milestone XProtect Matrix
manual.
Add Device:
Starts the [Device Setup Wizard]. ( Page 40)
Edit Device:
Opens the [Edit device settings] window. ( Page 41)
Remove Device:
Lets you remove a device selected in the [Device
Manager] section.
Settings:
Lets you specify settings for a selected camera or audio
source.
I/O Setup:
Opens the [I/O Setup] window. ( Page 47)
Event Buttons:
Opens the [Event Buttons] window. ( Page 50)
Generic Events:
Opens the [Generic Events] window. ( Page 51)
I/O Control:
Opens the [I/O Control] window. ( Page 53)
Exit:
Closes the [Camera Record Setting] window.
● Analog Cameras
In the VR-N900U, analog input circuitry is considered a
network encoder (IP video server) and the IP address
192.168.201.12 has been set. The registered address [N900
(192.168.201.12)] will appear in the [Device Manager]
section on the [Camera Record Setting] window.
The analog cameras that are connected to [VIDEO IN 1-4]
terminals on the rear panel correspond to N900 cameras 1
to 4.
You can change the default name (N900) by clicking the
[Edit Device] button, but you cannot change the IP address
(192.168.201.12).
Note
• The audio signal which is inputted into [AUDIO IN] audio
input terminal 1 and 2 of the rear panel will record and
archive as the audio of the analog camera which is
connected to [VIDEO IN] camera image signal input
terminal 1 and 2. (Same applies for the network encoder
which has the multiple image and audio input terminals of
VN-E4, etc.)
☞
☞
☞
☞
☞
☞
☞
☞
☞
