Filter
Top Products
59
Specifying an Output Port
A specific event or the clicking of an event button can be
associated with a particular output port.
To do this, specify the output port from which output will be
triggered when a specific event or manual action occurs.
1 Select [I/O Control] in the [Camera Record
Setting] window.
A dialog box will appear.
2 Select the required event from the list in the
left side of the window.
3 Select the required output and click the
button located below the [Selected Outputs]
list.
To remove an output from the [Selected Outputs] list, select
the required output, and click the button.
Output Settings for Cameras
You are able to associate a camera with particular external
outputs, defined in the [I/O Setup] window, for example the
sounding of a siren or the switching on of lights.
The associated outputs can be triggered automatically when
motion is detected as well as manually through output
buttons.
You access the [Output Settings] window from the [Camera
Settings] window ( Page 34), by clicking the [Outputs]
button.
● Selecting Output for Manual Control
You are able to specify outputs to be triggered manually
through output button or from a list in the [Live Viewing]
window.
1 Select the required output in the [All Outputs]
list.
2 Click the button located between the [All
Outputs] list and the [On Manual Control] list.
• This will copy the selected output to the [On Manual
Control] list.
• You are able to move a selected output up or down in the
[On Manual Control] list with the up and down buttons
located to the right of the list.
• To remove an output from the [On Manual Control] list,
select the required output, and click the button
located between the [All Outputs] list and the [On Manual
Control] list.
● Selecting Output for Use on Motion Detection
You are able to select outputs to be triggered automatically
when motion is detected in images from the camera.
1 Select the required output in the [All Outputs]
list.
2 Click the button located between the [All
Outputs] list and the [On Motion Detected] list.
• This will copy the selected output to the [On Motion
Detected] list.
• To remove an output from the [On Motion Detected] list,
select the required output, and click the button
located between the [All Outputs] list and the [On Motion
Detected] list.
[I/O Control] window
☞
[Output Settings] window