Filter
Top Products
90 C1695M (8/06)
ENABLING ENDURASTOR AND SETTING THE ENDURASTOR DELAY
EnduraStor allows video recorded at higher frame rates to be reduced to 2 ips after a predetermined delay (period of time). This reduction in
stored frames saves valuable hard disk drive space. The delay is the number of days of stored video you want to retain at full size. Video recorded
outside of this delay window will be compressed to make room for more recent recorded video. The default setting is 72 hours.
TIP: You can use an optional KBD5000 keyboard or a USB PC keyboard and mouse to perform some setup tasks more easily. Refer to
Understanding DVR5100 Controls and Menus on page 31 for a comparison on using any of these devices to work with the on-screen menus.
To enable EnduraStor and set EnduraStor delay:
1. If it is not ready open, select the Configuration tab for the DVR from the Devices tab on the Setup window. For information about displaying
DVR device options, refer to Displaying the EnduraStor Options on page 89.
2. Navigate to the EnduraStor enabled check box and select it. (Refer to Figure 75 on page 88.)
3. Navigate to the EnduraStor Delay field, and then use the on-screen keyboard to set the delay in hours.
4. Select Apply to save your changes and continue working with settings on this page. Select OK to save your changes and close
the page. To retain the original settings, select Cancel . The DVR5100 main application window is displayed.
ENABLING AND SETTING THE PRUNING PERIOD
EnduaStor provides a feature that will delete video older than a certain number of days. You can set the number of days for which video will be
retained before it is deleted. When enabled, the DVR5100 deletes all video that is older than the retention period. To save a video recording you
must lock it. Refer to the operation manual for instructions on locking video.
TIP: You can use an optional KBD5000 keyboard or a USB PC keyboard and mouse to perform some setup tasks more easily. Refer to
Understanding DVR5100 Controls and Menus on page 31 for a comparison on using any of these devices to work with the on-screen menus.
To enable and set the EnduraStor pruning period:
1. If it is not ready open, select the Configuration tab for the DVR from the Devices tab on the Setup window. For information about displaying
DVR device options, refer to Displaying the EnduraStor Options on page 89.
2. Navigate to the Delete Video Older Than check box and select it. (Refer to Figure 75 on page 88.)
3. Navigate to the Delete Video Older Than field, and then use the on-screen keyboard to set the pruning time in days.
4. Select Apply to save your changes and continue working with settings on this page. Select OK to save your changes and close
the page. To retain the original settings, select Cancel . The DVR5100 main application window is displayed.