Filter
Top Products
14 C1695M (8/06)
Hardware Installation
Equipment Placement and Rack Mounting
The DVR5100 can be placed on a flat surface, such as a desktop, or mounted in an equipment rack.
DESKTOP MOUNTING
To mount the DVR5100 on a desktop:
1. To prevent surface damage, be sure that the rubber feet are securely installed on the four corners of the bottom of the unit.
2. Remove the two chassis brackets (if attached) from the sides of the unit, using a Phillips screwdriver to remove the eight 10-32 x 0.25-inch
Phillips pan head screws (four per bracket). Save the brackets and screws for possible future use.
3. Position the unit to allow for cable and power cord clearance at the rear of the unit. Be sure that the air flow around the unit is not
obstructed.
Figure 5. Chassis Brackets and Rubber Feet
RACK MOUNTING
The DVR5100 mounts into an industry-standard 19-inch (48 cm) equipment rack. The DVR5100 occupies two rack units (3.5 inches or 8.9 cm) of
vertical rack space. The hardware necessary to mount the DVR5100 into a rack is supplied with the unit.
The rack must meet the following requirements:
• Rack standard: 19-inch EIA-310-D compliant (rear column required).
• Rack column depth: 20 to 30 inches (50.8 to 76.2 cm).
• Column mounting hole provisions: 10-32 UNF-2B threaded holes or square window holes on front and rear columns.
• Door systems (optional): Front doors must have at least 2 inches (5.1 cm) between the DVR5100 front bezel and the inside of the door.
Rear doors may be used only on rack columns that are more than 26 inches (66.0 cm) deep.
WARNING: Do not place the DVR5100 unit on its side; in this position, the unit is likely to fall over and may cause equipment damage or
personal injury.
WARNING: Slots and openings in the cabinet provide ventilation to prevent the unit from overheating. Do not block these openings.
Never place the unit near or over a radiator or heat register. When placing the unit in a built-in installation, such as a rack, be sure to
provide proper ventilation. Allow at least one rack unit (1.75 inches or 4.44 cm) of spacing between units
(4) SCREWS
PER BRACKET,
10.32 X 0.25-INCH
PHILLIPS PAN HEAD
(4) SCREWS,
8-32 X 0.25-INCH
PHILLIPS PAN HEAD
RUBBER FEET
CHASSIS
BRACKET