Filter
Top Products
C1695M (8/06) 91
ENABLING AND SETTING THE LOCKED VIDEO PRUNING
EnduaStor provides a feature that will delete locked video older than a certain number of days.
TIP: You can use an optional KBD5000 keyboard or a USB PC keyboard and mouse to perform some setup tasks more easily. Refer to
Understanding DVR5100 Controls and Menus on page 31 for a comparison on using any of these devices to work with the on-screen menus.
To enable and set the EnduraStor locked video pruning period:
1. If it is not ready open, select the Configuration tab for the DVR from the Devices tab on the Setup window. For information about displaying
DVR device options, refer to Displaying the EnduraStor Options on page 89.
2. Navigate to the Delete Video Older Than check box and select it. (Refer to Figure 75 on page 88.)
3. Navigate to the Delete Video Older Than field, and then use the on-screen keyboard to select the pruning time in days.
4. Select Apply to save your changes and continue working with settings on this page. Select OK to save your changes and close
the page. To retain the original settings, select Cancel . The DVR5100 main application window is displayed.
CONFIGURING SERIAL PORT SETTINGS
TIP: You can use an optional KBD5000 keyboard or a USB PC keyboard and mouse to perform some setup tasks more easily. Refer to
Understanding DVR5100 Controls and Menus on page 31 for a comparison on using any of these devices to work with the on-screen menus.
To configure the serial port settings:
1. If it is not ready open, select the Configuration tab for the DVR from the Devices tab on the Setup window. For information about displaying
DVR device options, refer to Displaying the EnduraStor Options on page 89.
2. Under Serial Port Settings, modify the following settings:
• In the BPS list, select the speed. Available speeds range from 110 to 230400. The default speed is 2400.
• In the Data Bits list, select the number of data bits. Available bit rates range from 5 to 8. The default value is 8.
• In the Parity list, select the parity. Choices are None, Odd, and Even. The default parity setting is None.
• In the Stop bits list, select the number for the stop bit. Choices are 1 and 2. The default stop bit is 1.
3. Select Apply to save your changes and continue working with settings on this page. Select OK to save your changes and close
the page. To retain the original settings, select Cancel . The DVR5100 main application window is displayed.