Filter
Top Products
114 C1695M (8/06)
DEVICES
Each device category contains a specific set of default settings. Refer to the following sections for a list of default settings for these device
categories.
• Alarms, below
• Cameras on page 114
• DVRs on page 115
• Relays on page 116
ALARMS
The DVR5100 provides one alarm input for each camera input. The default settings are repeated for alarms 1 through 16.
• Name: AlarmArray
• Alarm name: No default setting
• Alarm number: 1 to 16
• Camera Association: No default setting
• Physical input: 0
• Alarm number: 0
• Silence alarm: Enabled
• Supervised: Disabled
• Severity: Normal
• Polarity: Normally Open
• Dwell time: 5 tenths of a second
• Follow the input: Enabled
• Comments: No default setting
CAMERAS
General Settings
The DVR5100 can support up to 16 camera inputs. Each camera has the following default settings.
• Name: Camera 01
• Camera number: 1 (16)
• Camera type: Fixed
• PTZ control mode: Disabled
• Address: 1
• Camera groups (multi-valued): No default setting
Configuration Settings
• Covert camera: Disabled
• Video termination: Enabled
• Motion detection: Disabled
• Audio: Disabled
• Noise filter: Low
• Multicast: Enabled
• Unicast: Disabled
• Picture quality: Use system settings
• NTSC/PAL: Unavailable