Filter
Top Products
TLA 700 Series Installation Manual
1
Basic Installation
This chapter describes all of the steps needed to install the TLA 700 Series Logic
Analyzer. It is written from the perspective that you purchased most of the items
uninstalled and you intend to install all of the pieces. If you purchased a logic
analyzer with modules already installed, you should still review all of the
information in this chapter and perform those steps that apply to your specific
situation.
This chapter deals mainly with hardware installation. The basic operating
software is already installed on the internal hard disk. However, if you ordered
additional software, such as microprocessor support software, you must install
that software yourself. Refer to Installing Microprocessor Support Software on
page 15.
Check the Shipping List
Verify that you have received all of the parts of your logic analyzer. Use the
shipping lists that came with your logic analyzer to compare against the actual
contents of your order. You should also verify the following:
H Verify that you have the correct power cords for your geographical area.
H Verify that you have backup copies of the installed software. Store the
backup software in a safe location where you can easily retrieve the software
for maintenance purposes.
NOTE. Keep the software packaging available because you will need it to enter
the Windows 95 software registration number when you first power on the logic
analyzer. (See Step 6 under Power on the Logic Analyzer on page 11.)
H Verify that you have the correct module types and probes.
H Verify that you have all the standard and optional accessories that you
ordered.
Remember to fill out and send in the customer registration card. The registration
card is packaged with this manual.