Filter
Top Products
In Case of Problems
TLA 700 Series Installation Manual
31
Install color-coded ring on
the replacement cable and
slide the ring down the tool.
Installation tool
Replacement
cable
Figure 14: Installing the color-coded ring
17. Push the new podlet cable into the rubber comb.
18. Unwrap and remove the masking tape from the splice of the two cables and
discard the faulty cable.
19. Remove the protective 1x2 housing from the new podlet cable. Use the same
procedure as in Step 7 on page 28 to remove the plastic retaining snap.
Discard the retaining snap and the protective housing.