Filter
Top Products
In Case of Problems
32
TLA 700 Series Installation Manual
20. Insert the new podlet cable partially into the cable header housing. Place a
new retaining snap (included with the kit) on the podlet cable as shown in
Figure 15 and fully insert the cable and retaining snap into the cable header
housing. Tug lightly on the podlet cable to ensure the retaining snap is in
place.
Retaining snap
Cable header housing
Podlet cable
Figure 15: Installing the cable in the cable header housing
21. Reinstall the top and bottom probe housings on the module end of the probe
cable in the following manner (refer to Figure 10 on page 27 if necessary):
a. Line up the two tabs on the probe header with the two embedded slots in
the bottom (deep) probe housing.
NOTE. It may be necessary to push or pull the cables in the sleeve so that the
probe header lines up properly with the slots in the bottom probe housing.
b. Place the two metallic guides on the probe sleeve in the slots in the
bottom probe housing.
c. Line up the three tabs of the probe header with the three embedded slots
in the top probe housing.
d. Install and tighten the four screws in the probe housing.
e. Smooth the sleeve by hand to ensure the sleeve fully covers the cables
when replacing the probe housing over the comb.
22. Repeat step 21 to install the probe housing over the rubber comb on the
podlet end of the probe cable.