Filter
Top Products
Appendix A: Merging Logic Analyzer Modules
36
TLA 700 Series Installation Manual
12. Push forward on the cover so the tab on the front edge of the cover inserts
into the rear of the front subpanel. Make sure that the cover is fully seated
(no gaps) against the front and rear chassis flanges (see Figure 18).
Leave no vertical gap
Make sure tab inserts into
slot on rear of front panel
Figure 18: Seating the cover on the chassis
13. While holding the cover in place, install the four screws nearest the front of
the module (two on the top and two on the bottom), to secure the cover to
the chassis.
14. Install the flat-head screws near the front of the module.
15. Slide the rear panel on the chassis and install the two rear panel screws.
16. Install the top and bottom rear screws.