Filter
Top Products
In Case of Problems
26
TLA 700 Series Installation Manual
The podlet replacement procedure consists of identifying the faulty podlet and
replacing it with a new one. A podlet replacement kit is available as an optional
accessory.
NOTE. Refer to the TLA 700 Online Help for part numbers of the TLA 700
accessories.
Equipment and Required Material. You will need the following equipment and
material:
H Replacement podlet
H Masking tape
H Small diagonal cutters
H Screwdriver with #1 Phillips tip
Replacement Procedure. Perform the following steps to replace a faulty probe
podlet:
1. Identify and mark the faulty podlet.
2. Disconnect the probe from the logic analyzer and set the probe cable on a
clean working surface.
NOTE. If you need to replace more than one podlet, replace the podlets one at a
time to avoid mixing them up.
Replacing Probe Podlets