Filter
Top Products
Basic Installation
TLA 700 Series Installation Manual
11
2. Connect the power cord.
CAUTION. Although the benchtop mainframe can use the power cord with the
15 A plug, mainframes operating at low line (90 VAC) with four or more
instrument modules may require the power cord with the 20 A plug. If you have
four or more modules in your mainframe, you must determine the correct fuse
and power cord combination to avoid overloading the power distribution system.
Refer to Power Cord and Line Fuse Requirements for the Benchtop Mainframe
on page 65 for further information.
3. If you have an external monitor, connect the power cord and power on the
monitor.
4. Press the On/Standby switch to power on the logic analyzer (see Figure 7 for
the switch location).
Figure 7: On/Standby switch locations
5. Wait for the boot routine and low-level self test to complete.
6. Follow the instructions on the screen and enter the Windows 95 Product
Identification number (located above the bar code) on the Windows 95
software package that came with your logic analyzer. Enter other information
as required.
The internal setup software will automatically configure your logic analyzer
and install all required devices depending on the installed accessories.
7. Restart your logic analyzer when the setup program is complete.
The next time you power on the mainframe, the logic analyzer application starts
automatically.