Filter
Top Products
Appendix B: Upgrades
42
TLA 700 Series Installation Manual
You can update or reinstall the TLA 700 software by executing the setup.exe
program on the Disk #1 of installation disks or by performing the following
steps.
NOTE. The following instructions assume that you are reinstalling the TLA 700
application software only. If you are installing the software on a new hard disk
drive, refer to the instructions under Reinstalling Software on page 56.
1. If the TLA 700 application is running, exit the application before continuing.
2. Insert the TLA 700 application floppy disk 1 in the disk drive.
3. Click Start, point to Settings, and click Control Panel.
4. In the Control Panel window, double-click Add/Remove Programs.
5. Click on the Install button and follow the instructions on the screen for
installing the software from the floppy disk.
If the setup program finds an earlier version of the TLA 700 Application, the
program will ask you to confirm your selection and then will remove the
software. At the end of the removal process, the program will ask you to
remove the floppy disk and then restart the logic analyzer to complete the
file removal process.
6. After the logic analyzer restarts, reinsert the floppy disk and repeat steps 1
through 5 to install the application software.
When executed, the setup program will replace old versions of the software after
you have confirmed your choice. The program also offers to delete shared files
which appear to be no longer needed by any application.
The program will not remove saved TLA files or microprocessor support
packages.
You can also remove or uninstall the TLA 700 software using the Uninstall
program. Use the Add/Remove Programs tool under the Control Panel to
uninstall software.
NOTE. The TLA 700 Software Setup program automatically invokes the Uninstall
program before reinstalling the TLA 700 software.
Upgrading or Reinstalling
TLA 700 Software
Uninstalling TLA 700
Software