Filter
Top Products
Appendix A: Merging Logic Analyzer Modules
TLA 700 Series Installation Manual
37
17. Check and tighten all screws to 4 in lbs.
18. Place the Master module adjacent to the Slave module so that the two guide
pins from the Slave module line up with the guide pin holes in the Master
module (see Figure 19).
Master module
Slave module
Guide pins
Figure 19: Lining up the two modules
19. Gently push the two modules together so that the Merge cable of the Slave
module mates with the Merge cable connector on the Master module.
Installing the Merged Modules in the Logic Analyzer
After merging the two modules, perform the following steps to install the
module pair in the logic analyzer:
1. Hold the module pair such that the two modules do not become separated
and line up the modules with the slot guides in the logic analyzer.
2. Push both of the modules in the logic analyzer until they rest against the rear
panel connector. Use the injector/ejector handles to fully seat the modules
one at a time. Tighten the module retainer screws.