Filter
Top Products
Appendix B: Upgrades
48
TLA 700 Series Installation Manual
After you set up the logic analyzer, you must set up the client machine using the
following procedure:
1. Install and configure TCP/IP. (networking)
NOTE. If you have difficulty configuring the network setup, contact your system
administrator.
2. Load the Tektronix TPI Client Install diskettes supplied with the logic
analyzer.
3. Double-click on Setup.exe.
4. Click Start and then Shut Down. In the Shut Down Windows dialog, select
Restart the Computer? and then click the Yes button.
5. Depending on the type of access control you chose for the logic analyzer,
double-click <install directory>\System\TPI\Share Level Access
Client.reg or User Level Access Client.reg.
6. Restart the client machine, using the procedure in step 4.
7. In Microsoft Windows NT, click Start, and then select Run. Either locate the
dcomcnfg file using Browse, or enter dcomcnfg. Then click OK.
8. Double-click Tektronix TLA 700 Application in the Applications page.
9. In the Location page, check the “Run application on the following computer”
box. Enter the name of the logic analyzer in the edit field.
To verify that the setup is complete, do the following:
1. Run <install directory>\Samples\TPI Samples\Vc++\test client\test-
client.exe on the client machine.
2. The Tektronix Test TPI Client dialog appears. Click the Connect to
TLA 700! button to see if the client can connect to the logic analyzer.
3. Attempting Connection to TLA 700 appears in the dialog text box.
(The first time you connect, it may take a few minutes.) The text changes to
Connected! when the connection is made.
This completes the setup of the logic analyzer and the Windows NT client
machine for running your client application across the network.
Setting Up a Client
Machine that is Running
Microsoft Windows NT