Filter
Top Products
Chapter 5 Customizing NV DVR System
62
- Enable/disable the Abnormal Event check box, to set the condition of the event for
system to alarm.
• Normal Reboot: when the NV DVR system reboot without abnormal condition,
the system will send out the alarm message.
• Abnormal Reboot: when the NV DVR system reboot in irregular condition, the
system will send out the alarm message.
• Recording is switched off: when the recording has been stopped, the system
will send out the alarm message.
• Network is switched off: when the network connection of DVR system is lost,
the system will send out the alarm message.
• Hard Disk failed: when the hard disk can’t work normally, the system will send
out the alarm message.
• Temperature: set a temperature limited of system for system to alarm. When
DVR system temperature is over the temperature limited, the system will send
out the alarm.
i
Temperature setting only supports on NV6000 Express card.
• Illegal Entry: any objects move between selected regions which user has set up
in Object Counting section (see
Chapter 5.2.1), the system will send out the
alarm. Select the entry (object moves from region 1 to 2 or from region 2 to 1)
and camera for system alarm detection.
i
Only the camera has been setup in Object Counting will be available
for selecting in Illegal Entry.
- Enable/disable the POS Keyword check box, to scan the data from the POS if it
matches the keyword (see also
Chapter 5.9.10).
- Enable/disable the Alarm Message check box, to active with external alarm
message by your own program. For the detail configuration, please contact the local
reseller.
- Continue trigger duration: Set a time period that when sensor has been trigger
and stay in the same status for that period, then the alarm will be sent out.
6. In (5) Alarm Reset, click the camera number (use W and X to select the alarm) to set the
reset condition of alarm. Once alarm is reset, all alarm action will stop at the moment. If
the sensor normal status is high, set the sensor condition to low.