Chapter 5 Customizing NV DVR System
64
- Relay Output
Set to enable/disable the relay operation when the alarm is activated and to extend
additional time in second before it stops the relay operation (see also
Chapter 5.9.1).
- Play Warning Sound
Play alarm sound. To setup click Detail (see also
Chapter 5.9.2).
- Make Phone Calls
Dial and contact the number in the list. To setup click Detail (see also
Chapter 5.9.3).
To use this feature, the PC must have a voice modem connected to it. The supported
audio system is only 8KHz and 16Bit mono.
- Send E-mail
Send an electronic text message. To setup click Detail (see also
Chapter 5.9.4).
- File Transmission via FTP
Upload file to remote computer thru FTP (File Transfer Protocol). To setup click Detail
(see also
Chapter 5.9.5).
- Start Recording
Record the video from the selected camera. To setup click Detail (see also
Chapter
5.9.6).
- SMS (Short Message Service)/MMS (Multimedia Messaging System)
SMS transmits only text messages to mobile phone. MMS transmits text messages
and images over wireless networks using the wireless application protocol (WAP).
Make sure your mobile phone support this feature and your PC is connected to
GSM/GPRS modem. To setup click Detail (see also
Chapter 5.9.7).
- PTZ preset point
Position the PTZ camera based on the preset point setting. To setup click Detail (see
also
Chapter 5.9.8).
- Alarm SOP (Standard Operation Procedure)
List the instructions to inform the person of what to do when the alarm is activated. To
setup click Detail (see also
Chapter 5.9.9).
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video to CMS when the alarm is activated
(see also
Chapter 5.9.10)
- Launch Program
To call up the external program that is provided by 3
rd
party. Click
Detail
and click
to locate the program path. Enable
Multiple instance
check box to allow the program
can be executed multiple times at the same time.
- Snapshot
Take a snapshot when the alarm is activated.
a. Select Camera: specify which channel video to be snapshot when the alarm is
occurred.
- Alarm Camera: when a channel has an alarm occurred, and then, the DVR
system will snapshot the channel video.
- Camera # (1~32): the selected channel would be snapshot when an alarm is
occurred.
b. Video Size: select the size of snapshot picture.
c. Number of picture: the number of picture that is going to be taken.
d. Snapshot Interval: a time gap for next snapshot
e. Save Path: a storage path for saving snapshot pictures.