Filter
Top Products
Outputs
112
VM200 UserÕs Guide
Using the REC BUSS OUT
The VM200 converts the REC BUSS stereo signal to analog using
20-bit 128-times oversampling D/A converters. The analog signal is
then output from the REC BUSS OUT connectors on the rear panel.
These connectors are unbalanced phone jacks with a –10 dB nominal
output level.
The REC BUSS also sends the left signal to channels 1, 3, 5, and 7,
and the right signal to channels 2, 4, 6, and 8 so that you can route
them to ADAT OUT 1–8 directly. This configuration enables you to
send two mixes to two different external recorders at the same time
(assuming one recorder is ADAT-compatible). (For more information
on ADAT OUT connections, see “Digital Connections” on page 159.)
Monitoring the REC BUSS OUT
You can monitor the REC BUSS OUT signal by connecting the MON-
ITOR OUT jacks to an amplifier and speakers. Set the Mon Sel (Mon-
itor Select) parameter on the
SETUP:SYSTEM 1:CLOCK/MON
page to
“REC-B” (see page 98).
You can also monitor the REC BUSS OUT signal through a pair of ste-
reo headphones connected to the PHONES jack. For more informa-
tion, see “Monitoring Signals” on page 97.
Viewing the REC BUSS OUT Meters
You can view the REC BUSS OUT level on meters that appear on the
CHANNEL EDIT/OUTPUTS
function page. You can display this function
page by pressing the
[CHANNEL/METER]
key twice.
See the “Monitoring” chapter on page 97 for more information.
Note:
If the ADD. AUX parameter is on, the REC BUSS is disabled.
Fore more information, see “Enabling AUX Sends 3 & 4 (ADD. AUX
Parameter)” on page 115.
REC BUSS OUT meter