Filter
Top Products
Effects
128
VM200 User’s Guide
Applying Effects
To apply an effect, you must do two things:
❑
route the signal to one of two effects processors, and
❑
return the processed signal back to the mix.
The following sections explain these tasks.
Selecting an Effects Processor
1.
Press the
[CHANNEL/METER
] key.
The VM200 displays the
CHANNEL EDIT
function page.
2.
Check the input channel, turn on the
[ON]
key, and raise the
fader for the channel.
3.
Press the
[EFF1]
or
[EFF2]
key in the Eff Edit section to select
an effects processor.
The selected key lights up and the VM200 displays the
EFF EDIT
function page, which includes parameters for the current effect.
4.
Recall the desired effects program from the Effects Library.
(For more information on how to recall the effects program, see
“Recalling Effects Programs” on page 134.)
Setting Effects Return
Before you send a signal to an effects processor, you must set up a
routing path to return it to the mix so it can be monitored and output.
Follow the steps below:
5.
Press the
[CHANNEL/METER]
key, then the
[17–20 EFF RTN]
key.
The
[17–20 EFF RTN]
key lights up.
Note:
When EQ Enable parameter is set to “EQ1–16,” both effects proces-
sors are disabled. For more information, see “EQ Enabling Channels” on
page 80.