Filter
Top Products
Touring the VM200
36
VM200 UserÕs Guide
[EQ EDIT] Keys
The
[EQ EDIT]
keys enable you to select channels for parameter edit-
ing.
When you press an
[EQ EDIT]
key, the VM200 displays the
EQ EDIT
function page for the selected channel (for example, EQ EDIT CH2).
This function page includes parameters that control a four-band
parametric equalizer. The bands are LO, LO-MID, HI-MID, and HI.
You can adjust the equalization by rotating the [GAIN], [FREQ], and
[Q] controls for each band.
For more information, refer to the table below, which describes the
function of the
[EQ EDIT]
key in different Fader Modes.
[EQ EDIT] key function
EQ Section Rotary Controls
The VM200 EQ section is horizontally subdivided into four sections:
EQ-LO, EQ/LO-MID, EQ/HI-MID, and EQ HI.
Each band features three knobs labelled Gain, Freq, and Q that con-
trol the parametric equalizer in EQ Edit mode.
The Gain rotary control sets the gain of the input preamps.
The Freq rotary control specifies the frequency.
The Q rotary controls adjust the selectivity of a filter. A narrow fre-
quency band indicates a high Q value; a wide frequency band indi-
cates a low Q values. (In the response curve, notice how a bell-shaped
curve grows wider as Q decreases.)
However, like many VM200 controls, in other operational modes the
EQ section knobs serve multiple purposes. For example, in Channel
Edit mode, the
[FREQ]
and
[Q]
knobs control the channels pan posi-
tion.
CH Input Channel
Master
Mode 1–8 (ANALOG IN) 9–16 (ADAT IN) 17–20 (EFF RTN)
CHANNEL
Edits EQ for
Channels 1–8
(Disabled if
EQ Enable for
Channels 1–8 is
turned OFF.)
Edits EQ for
Channels 9–16
(Disabled if
EQ Enable for
Channels 9–16 is
turned OFF.)
Disabled N/A
AUX1
AUX2
AUX3
AUX4
EFF1
EFF2
EQ/HI
EQ/HI-MIDEQ/LO-MIDEQ/LO
GAIN
FREQ
PAN
Q
PAN
FREQ
QFREQ
Q
FREQ Q
GAINGAINGAIN
PANPANPANPANPANPAN