Filter
Top Products
118
<Recorder Part> Reference
Manually Registering a Camera
(continued)
6 Click [Finish]
The camera has been added.
The added camera will be listed in “Hardware Devices” of
[Advanced Configuration].
Note:
● A camera can also be added by right clicking [Hardware
Devices] of [Advanced Configuration] and selecting [Add
New Hardware Device].
● Devices other than cameras (dedicated input/output
devices, etc.) can be added using the same procedure.
Adding a Camera License
To increase the registration allowance for NVR cameras,
purchase additional camera licenses and add them to this
unit. With additional licenses, up to 64 cameras (32
additional) can be registered for VR-X3200U, and up to 32
cameras (16 additional) can be registered for VR-X1600U.
Note:
● For purchasing additional licenses, consult your nearest
JVC KENWOOD dealer or service center.
1 Double-click [Management Application] on
desktop
2 Click [Help] and select [About...]
3 Enter the license code in the [Software license
code (SLC)] field, and click [OK]
If the code is valid, the number of licenses will appear.
Replacing a Hardware Device
This section describes procedures to replace a hardware
device currently used such as a camera with a new hardware
device.
● Use the [Replace Hardware…] wizard for configuration
after connecting a new hardware device.
1 Double-click [Management Application] on the
desktop
2 Click [+] in [Advanced Configuration]
3 Click [+] in [Hardware Devices]
4 Right-click the hardware device you want to
replace and select [Replace Hardware Device]
The wizard is launched.
5 Follow the instructions of the wizard to enter the
IP address, port number, user name, and the
password of the new hardware device
6
Select the driver for the new hardware device from
the [Hardware device type] list and click the [Auto
Detect/Device Type Confirmation] button
The driver is configured.
● If you click the [Auto Detect/Device Type] button without
selecting a driver, a necessary driver will be
automatically detected and configured.
7 Confirm the serial number (MAC address)
Changing the System
Configuration (continued)