Filter
Top Products
37
11 Click [Finish]
Return to the top window.
In the end, restart the service so that the specified settings
are applied. (A Page 33 "To close Management
Application")
Basic setup of the monitoring system has been finished. Now
you can receive, view and record images from installed
cameras.
To ensure sufficient data storage on this unit, be sure to add
additional HDD and make the appropriate saving method
settings.
Ⅵ Building a RAID10 configuration
By adding internal HDD you can increase the storage
capacity.
Furthermore, the data duplication and dispersion achieved
through using RAID allows for more secure data and high
speed saving.
As this unit supports RAID10, you can build a RAID10
configuration to achieve the maximum recording
performance (frame rate).
For adding internal HDD and building a RAID configuration,
see "Adding an HDD" (A Page 71) and "Building a RAID
Configuration" (A Page 72).
Ⅵ Setting the recording data and archiving
destination to the same drive
By setting the recording data and archiving destination
(recording path/archiving path) to the same drive, you can
reduce the strain on this unit when moving data.
Set the recording/archiving path in [Cameras and Storage
Information] in [Advanced Configuration] of Management
Application. (A Page 100)
Ⅵ Making settings to erase old recordings
By setting an appropriate storage period for recording data,
old recording data will be erased at fixed intervals to retain a
constant capacity.
Set the storage period for recording data in [Cameras and
Storage Information] in [Advanced Configuration] of
Management Application. (A Page 100)
Making Full Use of
Recording Performance