Filter
Top Products
75
RS-232C
$
Time lapse control commands
These commands are not acknowledged while a search control command is being processed.
Data transmitted by PC Data returned from unit in response Description of command
[STX] LAD:m [ETX]
Parameter
m = 0: 30 seconds
1: 1 minute
2: 1 minute and 30 seconds
3: 2 minutes
4: 3 minutes
5: 6 minutes
6: 10 minutes
7: CONTINUE:
Recording continues until
the tape-end.
8: MANUAL:
Recording only while an
alarm signal is input.
[STX] LAD [ETX] Sets the time during which alarm recording or sensor
recording is to be performed.
[STX] LAI:m [ETX]
Parameter
m = S: STOP
Stop mode established at
tape-end position.
C: CONTINUE
Alarm signal input is
ignored.
[STX] LAI [ETX] Sets the operation mode that is to be established when an
alarm signal has been input at the tape-end position.
[STX] LBM:m [ETX]
Parameter
m = N: ON
Output of the black burst
signal.
F: OFF
No output of the black burst
signal.
[STX] LBM [ETX] Sets the processing to be performed for the black burst
signal when the video signals to be output from the video
signal output connectors are switched.
[STX] LBP:m [ETX]
Parameter
m =
¢
: Video signals of all the
cameras are output.
0: Camera 1
1: Camera 2
2: Camera 3
3: Camera 4
4: Camera 5
5: Camera 6
6: Camera 7
7: Camera 8
8: Camera 9
9: Camera 10
A: Camera 11
B: Camera 12
C: Camera 13
D: Camera 14
E: Camera 15
F: Camera 16
[STX] LBP [ETX] Prevents the video signals of the camera designated by the
parameter from being output from the VIDEO OUT
connector.
[STX] LAR [ETX] [STX] LAR [ETX] Deletes the ALARM RECALL data.