Filter
Top Products
122
Superimpose screen
The control signals, time code, etc. are displayed on this
screen using abbreviations.
CTL: Control signal count value
TCR: Time code data recorded in the SBC area
TCR.: Time code data recorded in the VAUX area
UBR: User bits data recorded in the SBC area
UBR.: User bits data recorded in the VAUX area
TCG: Time code data of the time code generator
UBG: User bits data of the time code generator
<Note>
[T¢R], [T¢R.], [U¢R] or [U¢R.] is displayed when the data
has not been read correctly from the tape.
Characters displayed
The background of the characters superimposed on the
display screen can be changed using (C TYPE) on the
<TC SHIFT> menu.
<Note>
When the 23/24 Hz mode, 25 (HD) mode, or 50 (HD) mode
is selected in System Menu No. 25 (SYSTEM FREQ), any
superimpose, such as the time code of the SD SDI
MONITOR/VIDEO OUT3 connector, is not displayed. When
the 25 (SD) mode or 50 (SD) mode is selected, any
superimpose, such as the time code of the HD SDI
MONITOR connector, is not displayed.
Display position
The position of the characters superimposed on the display
can be changed using (C HPOS) and (C VPOS) on
the <TC SHIFT> menu and the ADJ dial.
Operation mode
When T&STA or T&S&M is selected for (DISPLAY) in the
<TC SHIFT> menu, the VTR operation mode is also
displayed.
TCR ¢¢ : ¢¢ : ¢¢ : ¢¢
TV monitor
Abbreviations
F5
TCR ¢¢ : ¢¢ : ¢¢ : ¢¢
TV monitor
TCR ¢¢ : ¢¢ : ¢¢ : ¢¢
TV monitor
F2 F3
TCR ¢¢ : ¢¢ : ¢¢ : ¢¢
TV monitor TV monitor
TCR ¢¢ : ¢¢ : ¢¢ : ¢¢
F4
TCR ¢¢ : ¢¢ : ¢¢ : ¢¢
STOP
TV monitor
VTR operation mode